cisco full-deplex

merhaba

cisco 3650 swich üzerindeki 1. portta sorun gözüküyor

 FastEthernet0/1 is up, line protocol is up (connected)
  Hardware is Fast Ethernet, address is 3cdf.1edb.2e03 (bia 3cdf.1edb.2e03)
  Description:
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Half-duplex, 100Mb/s, media type is 10/100BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 172000 bits/sec, 45 packets/sec
  5 minute output rate 132000 bits/sec, 34 packets/sec
     7513223 packets input, 3742308249 bytes, 0 no buffer
     Received 1192 broadcasts (0 multicasts)
     0 runts, 0 giants, 0 throttles
     3 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     0 input packets with dribble condition detected
     5986099 packets output, 2480239311 bytes, 0 underruns
     0 output errors, 196521 collisions, 1 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out

direk sunucuya bağlı bu porttan ben bunu full-duplex yapmak istiyorum bu işlemi nasıl yapabilirim ?